Pay more attention to the feeding operation whether before starting the enamel reactor or during the operation of the reactor equipment, so as to avoid some loss impact on the equipment caused by wrong feeding. So let’s talk about some precautions when feeding the reactor equipment, hoping to help you.
(1) Frequently check whether the agitator bolts in the enamel reactor are tightened and cannot be loosened to prevent the nuts and bolts from falling into the reactor. Tools, etc. are not allowed to fall into the kettle.
(2) Reduce the large temperature difference between the material and the kettle wall, and prevent the internal stress caused by the large temperature difference between the hot kettle and the cold material or the hot kettle and the cold material from affecting the service life of the equipment.
(3) Each batch of raw materials used in the enamel reactor shall be carefully inspected to ensure that there are no other impurities. In particular, it is forbidden to carry metal or sundries or hard blocks into the reactor, otherwise the enamel will be easily damaged. For example, several times, small iron blocks and iron filings were sandwiched in the citric acid raw material bag used for the production of sodium citrate. Fortunately, after the inspection of each bag of raw materials, the feeding was stopped in time, otherwise, the enamel would be damaged and the product would be unqualified, resulting in huge losses.
Therefore, when feeding the enamel reactor, we must pay more attention to these matters mentioned in the above Xiaobian. In addition, the operation shall be carried out in strict accordance with the correct feeding method, and the feeding shall not be carried out at will, otherwise the wrong feeding will not only cause loss to the equipment, but also cause some dangers and endanger the personal safety of the operator.
That’s all for the introduction of the above Xiaobian. I’m sure you’ve learned something here. If you have any other questions, you’re welcome to inquire.